Secondly, make sure you pay attention to the controls and temperature settings. As well as a thermostat, higher quality smokers come with meat thermometers built in. As you cook, the internal temperature of your meat is going to rise, and unless you’ve got a meat thermometer, there’s no way of knowing exactly how hot it’s got. If you don’t know why this is bad, when you let food sit too hot for too long, you run the risk of drying it out. You’ll undo all of your good work, plus it just tastes bad.
First, it’s really easy to use, with an electric auto ignition and shutdown system, plus LED controls that make setup idiot proof. Once it’s up and burning, the built in temperature sensor and meat probe make knowing what’s going on inside simple, especially considering that the thermometer is one of the most accurate I’ve seen, with only around 10 degrees variance. It’s got multiple settings if you’re using it as a meat smoker, as well, so you can control your flavor.
Even seemingly perfect pellet grillers have trouble getting the cleanup part right even in light of how little ash is produced by pellets. You should search for pellet smokers and grills that efficiently keep the ash from building up on the heat deflector that’s located underneath the grates. The ash should remain on the ash cup and nowhere else. Meanwhile, major cleanup with soap and water is a hassle that requires an apron and gloves.
Let's just say I really love to cook! Especially BBQ. I've had the YS640 a couple months now and can't say enough great things about it! I've grilled ,smoked and high temp roasted with excellent results! After week's of comparing and watching videos I know I made the right decision. There's just no comparison to the Chinese makes and the over priced stainless steel models. I considered the MAK smokers but at double the price couldn't justify it. For the price and USA build quality there isn't anything that can touch the Yoder!
I have used Bradley, Masterpiece, Green Egg, New Braunfels, Oklahoma Joe, Weber and now Traeger. So there is some experience in these comments. The “set it and forget” it is a misnomer and should not be used with Traeger (or any smoker/grill.) With Pellet Drive before you buy Read up on Er codes. The worst is when the fire pot fills up with pellets because the fire can’t keep up with the auger push and the whole cook is ruined or delayed. You have to pull everything out and basically start over while your expensive prime brisket is trying to be saved in the oven. Doesn’t matter what the weather is or wind conditions. Doesn’t matter if you stare at it and stir the hopper continuously. It will happen. Customer support at first was well you are at fault (didn’t leave the lid open on fireup for exactly 2 to 4 minutes or didn’t vacuum out the firepot between every cook) which is crazy. Finally, after so many calls over the past 6 months they are trying to make it right. Problem is, DO NOT believe the “set it and forget it.” That does not exist with any good cook. I have replaced the controller the fan and now getting a new probe. Do not waste your money. Unless someone out here in BBQ land can give me a recommendation on a product that won’t do this stay away from Pellet Drive?