Great reviews. I have been lately looking into pellet poopers. I currently own a large Big Green Egg and a Pit Barrel Grill. My Egg has limited space. On the PBC (Pit Barrel Cooker) I can cook a ton of food as it uses hanging meat method. But it has zero temperature control on it. A set lower vent and that’s it. You have to adjust the lid to get the temps up. I have adjustable rings for my Egg that allows for increased capacity. Eggs are great smokers, grills and ovens. I do have a FireBoss temp controller for the Egg which will allow a set it and forget operations. Wifi controls also. With that being said, I am looking for increased capacity in my cooks. I was seriously considering a XL Primo Oval or a XL BGE. Then I found these pellet poopers. After reading this blog and other reviews I found some limitations. One the lack of smoke flavor. Now with my Egg I add chunks of wood into the lump for smoke flavor. Same with the PBC. The PBC has different smoke flavor as the fats and juices from the meat drip on the hot coals which ignite (according to PBC’s website) and produce a smokey flavor in the meat. I’ve read two ways to increase the smoke flavor in Pellet Poopers. One is to start at a lower temp for a few hours, then crank it up to cooking temps. Two is the smoke tubes or Mojo Bricks. My question is do these techniques work? One review on the smoking tube said that they really didn’t make that much of a difference. Another issue was for grilling and the lack of direct heat. Grill Grates would eliminate this concern correct? My understanding of Grill Grates is that they provide a way to direct grill in an indirect environment. That’s a limitation with both of my cookers. The Egg can Indirect or Direct grill. Not both. Yes I can remove the indirect piece and set up the Egg for direct grilling, but you risk burnt fingers even with welders mitts on. Wouldn’t the Grill Grates on a Pellet Pooper solve this problem? Allowing you to slow cook that steak to say 10 degrees shy of your temp range then sear it on the grill grate for the a couple of minutes on each side to get it to your desired temp range? Or go the other way, sear first for a few minutes per side then indirect cook it to the desired temp?
Take your outdoor cooking to the next level with the Camp Chef Pellet Grill and Smoker. Designed with the home griller in mind, built-in features simplify the process of smoking. The included digital temperature readout takes the guesswork out of the cooking process. An advanced digital temperature chip gives a more steady smoke and temperature, eliminating large temperature swings and giving a more consistent cooking temperature. Our patented Ash Can Cleanout System makes clean up the easiest out there. The Pellet Grill and Smoker features range from innovative digital smoker controls to dual temperature sensors. Discover the real secret of award winning BBQ cooks, low and slow smoking.
Temperature range is an important factor. What you’ll need will depend on what kind of cooking you want to do. Top pellet grills can hit temperatures between 180 F to 425 F, enough for baking, smoking, roasting, and grilling. On the other hand, ioif you want to sear meat you need something that reaches the 500-550 F range. A functioning thermometer is a must. You’ll need a precise and accurate reading so you’ll know you’re cooking your meat at the right temperature.
I have used mine Traeger 15 times and it hasn't worked once. I will not hold the temp within 15 degrees as they state. I can set mine to 225 and will go between 180-370. It also consistently shutting itself off with the same error. I have spoken to cust service 12 times and they are worthless. I have had new controller sent and other various parts. I have been on the phone with them for hours. I always have to take my meat off and finish it on my Weber. They refuse to send me a new one. They still demand to go back through the same damn steps as the last 12 times to debug it. Never again. If you see my post on Craigslist, don't buy it, it's a lemon that Traeger will not support.
For me, I don't care where it is built; it could be Oregon, China or the moon. But I want a smoker that is reliable. As a businessman, I don't understand this company. It is going to be a lot more expensive for the company when I return this thing to Costco and Costco makes Traeger take it back. Just being responsive and sending a new controller under warranty would seem to be easier and cheaper. Of course, if this was a normal company, they would fix the root cause (poor reliability) and make lots of money selling to happy customers. Read more
Background: I've had this flat top for a month now and do 99% of my cooking on it. I have it set up next to my kitchen balcony which allows me to cook outside in most weather conditions and allows me to keep my kitchen clean for the most part due to a natural gas hook-up that I have outside. I purchased the Natural Gas Kit Hose (NGKIT) and converted the flat top to only intake natural gas. Please note that once you make the conversion then you cannot convert it back to propane unless you get new orifices. I had to drill all 4 orifices with a #45 drill bit to ensure that sufficient gas will be funneled through to the flat top. This process took a couple hours and will take more if you don't have the proper tools.
A pellet hopper is what you put your pellets in. The grill will automatically help itself from the hopper and use it to maintain the temperature you want it to. More heat requirement will use more pellet, and less heat will use less. What you need to make sure is that you have a good sized pellet hopper so that your grill can keep using from it and you do not have to keep refilling the hopper too often. There are pellet grills out there that are powerful and gentle enough to be cooking for hours, and sometimes overnight, all thanks to its large pellet hoppers that keep replenishing and refueling the fire all throughout.
Good info, but it’s missing something… the cost to use. I’ve been looking for a long time to get into smoking. I have only ever used a propane setup for grilling. My main quesion is the cost to use propane vs charcoal vs pellets. I’m very interested in pellet smoking AND grilling. A couple times a week my wife and I will grill some chicken breasts or steaks. Can you breakout an approximate cost comparison to run the different methods? Appreciate it!
Thanks Kevin. I am about to buy both a 5 burner gas grill and a smoker for a new bbq island. Rather than buy both, will one of these higher end pellet grills take the place of a traditional propane grill? I can apply the funds for the gas grill to a higher end pellet if it can really do double duty. It has to be able to cook burgers and dogs and steaks etc. Just like a gas grill though. Thoughts?
I’m not sure of the dates on the above replies, its now Oct.2017, and I’ve had enough of the Bradley dig. smoker. I live on Long Island NY and the Bradley has trouble getting up to and holding temp. I’ve added a PID to it but have decided to take it up a level. I’ve done a bunch of research and I’m leaning toward the Yoder 640 with Comp. cart. unless you take me out of it. What would you be spending your money on today? I did buy a book though your site, I hope that helps.
The argument for bark is that it smolders really well, providing more smoke during the cook and therefore more smokey flavor. Think about it: When you put a log on the fire, the bark almost immediately begins to smoke and smolder. And therein lies the second half of the pro-bark argument: when cooking on an offset you use logs with bark, so why should pellets be any different?
Thank you so much for the kind words! I think you would be very happy with a smaller pellet grill / smoker. The wording changes depending on how you are using the device. For instance, if you are cooking at low temperatures you will get a stronger smoke profile then if you burn a pellet smoker / grill at its higher temperature range. One thing you could do for steaks is cook them at the higher range thus being able to get a sear much like you would on a direct heated Grill service, for instance on your Weber. Another option would be to cook the steak in the reverse see your method, by bringing it up to temperature at a lower smoker setting and adding some smoke flavoring that way, then removing it and bringing the smoker up to its higher settings so you can finish off the steak with some of the effect you would achieve on direct flame. I normally do this by bringing the steaks up to about 15 degrees below where I want them to finish. Then, I finish them off at the higher temperature to where they are about 5 degrees below my target. This usually means a few minutes on each side but I use a Thermapen to be sure.
Hey Bill! I think you’d be very happy with a Yoder pellet smoker. From a product and manufacturing standpoint, they’re great pellet smokers. If you’re looking at spending $1,700 and can perhaps go a little higher, you can then consider either a MAK grill or a Memphis Grill Pro Series. These are fantastic pieces of equipment. They are insulated at the point where the lid touches the body at closing, and provide superior convection cooking. Anytime you feel you want some extra smoke, you can always throw in an Amazn Pellet Tube or use a Mojo Cube. These will amp up your smoke profile in a manner you can predict and keep under control. I would NOT recommend adding anything foreign to your burn pot ever. Just keep things from the main pellet smoker function working as per the manufacturer’s design.
As you can see from the image of a Traeger Pellet Grill above, pellets move from a hopper (left) via an auger to a burn pot (far right). The rate at which the pellets are fed into the hopper is dictated by your Pellet grill’s thermostat. Extra fuel in the form of oxygen is blown over the burn pot to increase the burn rate and help regulate a nice, steady, and efficient burn. The lower your temp, the more smoke is created.